home | site map | contact

 




Grab-Hook, part of the Grab-R footing system, is engineered for strength and ease of use.

Click Here for a video presentation of Grab-Hook!

video | 2-bar install | 3-bar install | specifications

 

 

 
   Hold rebar securely in place

   No tie wire or braces necessary

   No excess lumber

   Fast, easy installation

Grab-R
 rebar saddle
Grab-Hook
 j-hook holder

CLICK HERE FOR MORE CAD IMAGES





2-bar installation
Insert the straight end of the j-hook through the two loops of the Grab-Hook.  Bring the j-hook up completely through the Grab-Hook.  Grab-Hook assembly is ready for the foundation.

enlarge>>
After dropping in the horizontal rebar using Grab-R cleats, hook one side of the rebar with the long rebar hook.

enlarge>>
Snap the two smaller loops with a downward tap of a hammer.

enlarge>>
The Grab-Hook is now installed.  Continue to place Grab-Hooks as needed, alternating the direction of the hooked end for each j-hook.  *Note for installation with two horizontals, the two smaller loops are attached to the innermost rebar and the bigger loop hooking both rebar pieces.

enlarge>>

3-bar installation
Insert the hook end of the j-hook through the two loops of the Grab-Hook.

enlarge>>
Tap (Hammer) the front loop to secure the Grab-Hook to the j-hook.  Grab-Hook assembly is ready for foundation.

enlarge>>
To additionally secure the j-hook, simply use the hammer's claw and twist the extension rod rightward to lock the hook in.

enlarge>>
After drooping in the horizontal rebar using Grab-R 3 Bar Cleats, install the Grab Hook loop to the outside horizontal bar.

enlarge>>
Snap the two smaller loops with a "side-tap" of a hammer to the center bar.  Installation is now complete.  Continue to place Grab-Hooks as needed, alternating the direction of the hooked end for each j-hook.

enlarge>>

Copyright © 2004-2007 QuickFormZ
www.quickformz.com